The Nikon Z's are a little short.
Plasti-dip spray or spray on truck bed liner (paint dept. @ Home Depot) would be a quick and easy solution.
Cut a piece of bicycle tire tube ....works great for me
A sheet of cork. You can get it in various thicknesses at a hardware store.
Thanks for all the great suggestions. Now I've got lots to think about.
As for Zebra wood, I've been using it for years with no ill effects. The piece I used for this spacer was a scrap from a dead pedal I made for my Jeep.
CO - thanks for the offer, but I think I'm good now.
--
Bill_de wrote:
Thanks Joe. Sounds like the most practical idea.
--
You can get neoprene washers at Ace - an OK solution. You could also cut a piece of rubber gasket material to fit - from the plumbing dept. at Ace - a BETTER solution.
..
Very organic looking! A thin piece of cork? I have tripod plates lined with cork.
I would suggest a slightly different design. I would cut the pattern to be only the width/shape of the camera base but make it 1.5 inches thick. That way you would have a full grip and your little finger would not be placed on a platform. That should increase camera stability. But you still need the buffer to prevent any scratches.
After looking at it again, you already did what I suggested but not as thick. Sorry for not looking more closely when I read the first part.
Some types of rubber gasket or neoprene will tend to stick over time when kept under pressure (like a tight anchoring 1/4" bolt). I suggest making your "spacer" out of leather. Our local Tandy store sells scraps at a very reasonable price. Just take your "plate" to the store with you and get a scrap piece of chrome-tanned skirting leather that will fit. Take care & ...
Could you cut a window in your spacer large enough to open the battery door without removing the spacer?
I took a walk around my shop this morning and found something that should hold up pretty well. On the camera it is very comfortable without adding much to the size. Thanks to all those who commented and helped to get me thinking in the right direction.
--
That’s what I was thinking too. Felt will allow the wood plate to move easily. And by the way that’s a real nice piece of wood you cut I really like that very good job .
rmalarz wrote:
A layer or two of felt would probably work well.
--Bob
CO wrote:
I've made all sorts of thing I've needed for photography in a machine shop. For plastic parts, I've used delrin, nylon, and polyurethane. I order the materials from MSC Industrial supply. I made this Arca-Swiss plate for my 80-400mm lens and used a polyurethane that has a durometer of 95 for the lens support piece. That was just hard enough to machine without tearing the material but soft enough not to mar the lens. You can get it in different thicknesses and hardnesses.
You could make that entire piece out of 1/2" or 3/4" thick polyurethane. It would eliminate having two pieces that would shift around. I still have plenty of the material. I could cut a piece and send it to you.
I've made all sorts of thing I've needed for photo... (
show quote)
Add to your list of materials... Aegis II™ (a Linen Melamine based thermoset material), Elforyn, Ivorine, Juma, another thermoset plastic. Not sure if any are available in sheet form, I buy them by the rods.
If you want to reply, then
register here. Registration is free and your account is created instantly, so you can post right away.