PGHphoto wrote:
Some things to check -
1) When printing, do you have the printer driver's set to use printer or software color management ? From Adobe: If using Lightroom Classic and a specific profile, make sure color management is turned off in the printer driver software. Otherwise, your photos will be color-converted twice, and the colors might not print as you expect. See your printer’s documentation for instructions on turning off color management in the driver software. Lightroom Classic does not recognize CMYK printer profiles. To send the image data to the printer driver without first converting the image according to a profile, choose Managed By Printer.
2) Check the printer driver to see if color saving or draft mode is overriding the choice you make in Lightroom (or your print software).
What colorspace are you using ? sRBG vs Adobe RGB will have different appearances. Additionally, the resolution should ideally be greater then the 72ppi default. While it won't affect color much, it can make a difference in the appearance of sharpness. I typically find 400 - 500 ppi give best results on the Pro 100.
Finally, when printing black and white, make sure the print driver is set for monochrome in the printer panel. If you change a color image to B&W, I always have cyan or magenta tinged images printing directly through Lightroom. In those cases, printing from the Canon software will result in a much truer B&W image with no tinting/toning. The Canon print software can be installed as an add-in in Lightroom and you can quickly execute the Canon software from inside Lightroom.
It takes a little fiddling with the print driver and the Lightroom/software setup but once in place, the images on screen exactly match the print for me.
Some things to check - br br 1) When printing, d... (
show quote)
Assuming you are printing from Photoshop or Lightroom, make sure that the box to use LR or PS settings is checked and NOT the printer controls colors default. Also, always use the Adobe RGB and not sRGB color gamut. Set the DPI to 240 DPI (higher just uses more ink and does not improve your prints). Go into the Photoshop curves adjustment and set the shadow output to 8 and the highlight output to 244. That slight restriction will ensure that there is sufficient white ink on the paper so that the ink and not the paper defines the highlights and that detail is not lost in the shadows because of deposition of excessive ink. The default o and 255 settings are for screen viewing.