junglejim1949 wrote:
I recently purchased a lens hood for my 50mm. I have the lens on my camera and want to know if will hurt anything if I leave the lens hood on in the camera bag?
Being on the serious side, no problems normally.
Screw-on hoods are usually more secure than snap on type.
Should everything be stored loosely in a case, you might find things getting bent or cracked as the bag gets knocked around in normal use.
Lastly, a snap on type might fall off in a bag and/or wear out the holding device.
Sure you can. And if you leave the lens cap off as well you're ready to shoot when you pull your camera out of the bag. I don't do it that way - but you could.
Smudgey
Loc: Ohio, Calif, Now Arizona
tainkc wrote:
Yes. You will explode from spontaneous combustion.
That happened to me once, it took a long time to recover.
It should not hurt anything if stored properly.
Most lens hoods today can be reverted to fit the lens in storage.
cjc2
Loc: Hellertown PA
If I would completely remove the lens hood for transport or storage I would most likely break or loose it. I keep mine on, reversed as necessary. Best of luck.
I turn mine around when putting the camera in the bag (or in any bag) to save space.
AzPicLady wrote:
I turn mine around when putting the camera in the bag (or in any bag) to save space.
I do this also with the dismounted lenses as well.
I always leave the hood on and turn it around if necessary to save space
A lens hood only "wastes" space in a camera bag if you would otherwise fill it.
When I used Nikons I glued 2 rear lens caps together so I could stack 2 lenses together and put 'em in a single padded compartment without them banging against each other. Except for the shortest lenses, a stack of 2 was usually too tall to fit in the bag if lens hoods were in the "normal" position. But as has been noted, if you can reverse the hood it adds practically no length to the lens - usually no more than an additional lens cap would.
I recently switched to micro 4/3 equipment, with its tiny lenses (compared to Nikon full frame), and still stack 2 lenses together using glued-together rear lens caps. But the short lenses are so short that I can usually leave a lens hood in its normal position and still get a stack of 2 into the camera bag.
I have always put lens caps on lenses when they're being carried in a camera bag, unless I'm in the process of shooting where I am frequently switching lenses. In those cases I'll leave the lens caps off until I'm basically packing things up for the day.
Try putting them on the bags strap.
If you want to reply, then
register here. Registration is free and your account is created instantly, so you can post right away.