GregS wrote:
Would think the ISO would be set for me in the A mode. Didn't see much difference in A or P mode. Definitely too much noise!
Yes, ISO could be set automatically, BUT if the ambient light is low, then ISO goes high and shutter speed can go slow, and the image suffers. Thats where knowing what the actual settings are for the image helps. Posting the EXIF for the image will show the actual settings used when the shutter snapped, which might explain things.
GregS
Loc: Central Illinois, USA
It was jpg. Yes, I did resize, but did not see much of a change in quality. The colors are off. Here is the original. (Don't tell my wife I cut her out during the cropping) :)
Most photos with this camera are crystal clear.
GregS
Loc: Central Illinois, USA
Guess that would help:
ISO - 1600
F - f/3
Exposure - 1/20
Auto
Focal length - 25mm
Flash - on
Metering - mixed
GregS wrote:
Guess that would help:
ISO - 1600
F - f/3
Exposure - 1/20
Auto
Focal length - 25mm
Flash - on
Metering - mixed
Looks like pretty high ISO and way too slow a shutter speed to me.
Sir: did you do a proper set up before using?
GregS
Loc: Central Illinois, USA
Guess I shouldn't rely on what Auto gives me. I was surprised how high the ISO was and how slow the shutter speed was. That would certainly explain things. As you can tell, I am no more than a basic photographer. That is why I love this site! One can never stop learning!
Thanks for your help!
GregS
Loc: Central Illinois, USA
Warrior....No, I did not. People were standing in line to have their photo taken in front of the flag. Since I have always had good luck with the Auto or P settings on this camera, never entered my mine...guess it should have!
More than likely, the White Balance was off. You shot under the wrong kind of light, and did not either use a flash, or reset the White Balance for the kind of light you were under. Or you may have had the settings right, but your camera is becoming defective. It is best to use a flash for all important shots, even if the lighting is such that you do not 'need' it. Read up on 'Fill Flash', and apply it. A Diffuser on your fill flash will be helpful, too.
GregS
Loc: Central Illinois, USA
Could be a combo of "all the above"..... :)
rmalarz wrote:
Greg, it appears to me that it's a white balance issue. I took the liberty of checking white balance and it made quite an improvement.
--Bob
WB set to Auto or to Daylight in a room with Tungsten lighting?
GregS
Loc: Central Illinois, USA
I believe it was florescent lighting. WB is auto on this camera. It's a "point and shoot" Olympus. I have an Olympus E500, but too cumbersome to carry around. Maybe I should though!
Lupin
Loc: West Sussex, U.K.
Have you checked that the camera settings are not accidentally locked in "macro" mode. I know it sounds ridiculous, but its happened to me a couple of times before realised what was going on, and can be quite easily overlooked.
Inexplicably blurry and out-of-focus images are the result.
I would set the ISO manually. That's what causes the grain most likely. Set it for flash, but adjust the flash intensity down if you can (if it's too high). Experiment with settings to get what you want with a temporary "model" to focus on and to tweak the settings before you step in front. Focus it, then switch to manual focus and try that, too.
If you want to reply, then
register here. Registration is free and your account is created instantly, so you can post right away.