Grampy Loc: Canton, Michigan

I also have a new FZ200. I followed Ron's instructions with no problem. Make sure you scroll down to the tools icon (wrench), then right. At that point you'll see numbers 1-8 at the top right of the screen. At that point, it's easier to scroll up to level 7 than down through levels 1-6.

Orca Loc: Little Egg Harbor, NJ USA

It drove me nuts in the beginning too. In the beginning I found 8 pages then couldn't find it again. I think its because I had it in IA mode. (no pages in this mode) I think its also in the manual. Difficult to find. Don't know why you only have 6 pages in that section of the menu. I have 8 in every mode but IA. I will look again to see if I can help you.
Ron

Orca Loc: Little Egg Harbor, NJ USA

As I was checking the manual I remembered that I could not find out how to format the card in the camera. I gave Panasonic a call and they walked me through it. I'm getting older so I don't feel bad any more asking for help. Since you only say there is 6 pages I would give them a shout. They were very helpful. Not a long wait to get a person either. Hope this helps in your case. Let us know what happens.
Try this:
If you are not in the set up mode there are only 6 pages.
When you press Menu/Set and the screen comes up press the left side of the Menu/Set then go down to the wrench on the left side. You should now see 8 pages on the top. You can move faster between pages by using the Zoom lever on the top of the camera. This will jump from one page to the next.
Ron

VHD-Tex Loc: Mc Allen Tx.

Orch-- Thanks for taking time to help me. I guess I am in the set up mode and not smart enough to get out of it but I will keep trying. I have a hammer near so that should fix it..right.

Orca Loc: Little Egg Harbor, NJ USA

1. Turn Camera Off
2. Turn Top Shooting position to P
3. Place lever on left of lens to AF
4. Turn on Camera
5. Have LED screen on to follow the following steps.
6. Press Menu/Set on rear of camera.
7. When screen comes up press the little box with a plus in it that is to the left of Menu/Set one time.
8.You will now see a camera on the left of the screen off set from the yellow line.
9. Now below the Menu/Set push the self timer (looks something like a clock) two times and this should highlight the wrench to the left of the yellow line.
10. Now press the WB, on the right of Menu/Set one time.
11. Look at the top of the screen and you should see the numbers 12345678. These are your pages.
9. You can now go to page 7 by continuing to press the timmer. This will take you down on line of each page each time you press it. After the last line on the page you will go to the next page (line one). Continue pressing the timer till you reach page 7 , going one line at a time.
10. Once you get use to going into this part of the menu you can skip from page to page by moving the zoom lever one movement to the right or left. Don't do this until you are comfortable moving in the menu.

If none of this works for you you can send me a e-mail with you phone number and we can go through it by phone. Sometimes that's easier.
e-mail: rpttrsn@aol.com
Ron