I have a 5D Mark IV with a loose rubber ring on the MODE Dial. I tried all kinds of glue from Crazy Glue and Duco Cement and others with little success. I contacted a Hogger Friend (RJRiggins) and suggested PLIOBOND. I looked everywhere but was not successful. After a long search I finally found a half pint jar on Amazon. It is made by The Ruscoe Co., 485 Kenmore Blvd., Akron, Ohio 44301. The phone number is 800-293-8148.
Lay down a lot of paper towels. This stuff is extremely sticky and smells bad. I cut a small sliver with a craft knife in the rubber ring since the rubber expanded a small amount. Even though it has a Brush In The Can, I used a fine Art Brush to apply the glue only where I wanted it to go.
I will keep this stuff in the garage away from my sensitive nose.
So ... did it do the job?
How do I get a hold of RJ Riggins. He used to be on here pretty regular but havn't heard anything from him in years. He's a good guy.
tramsey wrote:
So ... did it do the job?
How do I get a hold of RJ Riggins. He used to be on here pretty regular but havn't heard anything from him in years. He's a good guy.
It worked very nicely. It was neat and feels good when I select a mode.
You could try sending a private message to: rjriggins11. He repaired the “joystick” knob on the same camera.
If you want to reply, then
register here. Registration is free and your account is created instantly, so you can post right away.