Tip to keep filters from sticking on camera lens
Jun 22, 2020 19:53:41 #
amfoto1
Loc: San Jose, Calif. USA
Aluminum framed filters are by far the worst for galling and sticking when threaded into aluminum or steel lens barrels.
Good news is that many lenses today use a tough plastic thread that prevents filters from sticking, regardless of the type of metal used in the filter frame.
But, if you ever stack filters for any reason (I store them stacked), aluminum to aluminum can be a real problem.
Brass filter frames are less likely to gall and get stuck than aluminum.
Some aluminum frames are coated with Teflon or other things to prevent them from sticking.
The trick with a pencil works... helps reduce stuck filters. Another thing that can work it to lightly rub the threads with a candle or other paraffin source. Just be sure to wipe off all excess to be sure none finds its way onto the glass.
It can also help remove tight/stuck filters to carry a couple rubber bands in your camera bag. Fit them over the filter and lens barrel to get a better grip on both. The wider ones the grocery store uses on produce are great for this... I occasionally ask them for a couple new ones. In fact, this reminds me it's been a while since I got a fresh pair of them... Time to go to the store!
Good news is that many lenses today use a tough plastic thread that prevents filters from sticking, regardless of the type of metal used in the filter frame.
But, if you ever stack filters for any reason (I store them stacked), aluminum to aluminum can be a real problem.
Brass filter frames are less likely to gall and get stuck than aluminum.
Some aluminum frames are coated with Teflon or other things to prevent them from sticking.
The trick with a pencil works... helps reduce stuck filters. Another thing that can work it to lightly rub the threads with a candle or other paraffin source. Just be sure to wipe off all excess to be sure none finds its way onto the glass.
It can also help remove tight/stuck filters to carry a couple rubber bands in your camera bag. Fit them over the filter and lens barrel to get a better grip on both. The wider ones the grocery store uses on produce are great for this... I occasionally ask them for a couple new ones. In fact, this reminds me it's been a while since I got a fresh pair of them... Time to go to the store!
Jun 22, 2020 22:12:15 #
Sometimes filters "stick" because uneven finger pressure on the ring distorts the metal filter ring so it binds the threads. Even if you can wrap your hand around it instead of just your fingers, the ring is distorted enough to be a problem. I have found that by wrapping the circumference of the filter with two or three layers of masking tape (don't overlap it on the lens) will keep it from distorting, then slowly pull on the end of the tape to remove the filter. Usually the layers of tape around the circumference keep the ring "round" enough so even when using your fingers/thumb to turn it, it will will come off.
Jun 24, 2020 14:04:46 #
azted wrote:
I'm surprised that no one has mentioned the Xume filter holders from Manfrotto. You can easily replace a UV filter with a polarizing filter as they are held in place by magnets, or remove the uv filter quickly if you don't need the protection. Great system!
I was wondering about that myself when I started reading through this thread; I was pretty sure I wasn't the only one, either, so I waited until I found your post confirming that. I totally agree with you! I have the Manfrotto adapter in 52mm attached to my Nikon d5300, and a total of 4 rings, one for each of the filters I use on this camera. Quick and easy changeouts!
If you want to reply, then register here. Registration is free and your account is created instantly, so you can post right away.