Yongnuo YN 622C-TX and YN 622C Firmware Updates
Aug 5, 2018 16:25:58 #
baygolf
Loc: DMV
Hi, can these devices firmware be updated using a Windows 10 computer? I remember when I first got these units you could only use Windows 7 to update the firmware.
THX
THX
Aug 5, 2018 19:52:24 #
Aug 6, 2018 08:33:58 #
baygolf
Loc: DMV
rmorrison1116 wrote:
Did ya check with Yongnuo?
There has been no update on the operating system for updates since 2015.
Aug 6, 2018 11:07:42 #
sandiegosteve
Loc: San Diego, CA
I wouldn't expect a response from Yongnuo. I do think I updated mine on Windows 10. It has been a while, but I've had W10 since before I got the YN-685N's and 622N-TX.
For W10/7, it is usually just getting the drivers to allow Windows to know what you plugged in. Often, W7 will work on W10. Sometimes W10 already has it. I think.
For W10/7, it is usually just getting the drivers to allow Windows to know what you plugged in. Often, W7 will work on W10. Sometimes W10 already has it. I think.
Aug 6, 2018 15:23:40 #
baygolf
Loc: DMV
sandiegosteve wrote:
I wouldn't expect a response from Yongnuo. I do think I updated mine on Windows 10. It has been a while, but I've had W10 since before I got the YN-685N's and 622N-TX.
For W10/7, it is usually just getting the drivers to allow Windows to know what you plugged in. Often, W7 will work on W10. Sometimes W10 already has it. I think.
For W10/7, it is usually just getting the drivers to allow Windows to know what you plugged in. Often, W7 will work on W10. Sometimes W10 already has it. I think.
Thank You!
If you want to reply, then register here. Registration is free and your account is created instantly, so you can post right away.