If you are new to DSS - make sure you do this..
Jan 24, 2016 10:17:06 #
Once DSS loads the final stacked and calibrated image, go to the processing section on the left side of your screen and select "save picture to file". Then check mark at the bottom of the dialog box that opens where it says to "embed changes but don't apply them". This will save the image as a 16 bit linear image file, which is what you want to start with.
Jan 24, 2016 12:13:28 #
nikonshooter wrote:
Once DSS loads the final stacked and calibrated image, go to the processing section on the left side of your screen and select "save picture to file". Then check mark at the bottom of the dialog box that opens where it says to "embed changes but don't apply them". This will save the image as a 16 bit linear image file, which is what you want to start with.
What is the advantage, what would it normally save it as???
Craig
Jan 24, 2016 13:55:32 #
CraigFair wrote:
What is the advantage, what would it normally save it as???
Craig
Craig
Non linear
Jan 24, 2016 14:04:04 #
CraigFair wrote:
What is the advantage, what would it normally save it as???
Craig
Craig
If you're going into Photoshop or light room it doesn't matter.
Jan 24, 2016 14:04:04 #
CraigFair wrote:
What is the advantage, what would it normally save it as???
Craig
Craig
If you're going into Photoshop or light room it doesn't matter.
If you want to reply, then register here. Registration is free and your account is created instantly, so you can post right away.