lovelylyn wrote:
I did order the Pixma pro 100 from adoroma with the $250 rebate
Now that you've taken the plunge (Congratulations, that's an exceptional printer! ), there are a few things Canon doesn't explain very well.
First, go to Red River Paper's review that covers everything from opening the box to custom print settings.
http://www.redrivercatalog.com/infocenter/articles/canon-pro-100-review-introduction-first-look-getting-started.htmlIf you're using heavy (fine art) papers, pay attention to the "Printing Preferences, then the "Maintenance" tab, then the "custom settings" That's where you'll find "prevent paper abrasion". They kind of hid it. :lol:
Most papers will be not more than 10-11 mils thick (thousandths of an inch). Some, like Red River's Blanco Matte, are actual woven poly/cotton fabric that's
18 mils thick! With normal settings the print head may drag on the paper leaving streaks or tear the edge of the paper (yup, I did that), or even damage the print head that costs over $100 to replace. By checking the "prevent paper abrasion" box, the print head is raised a few thousandths further from the paper surface and everything is good again.
Sometimes you want to lie to the printer about what paper you're using. If you specify "fine art papers" or use ICC profiles for same, the printer will leave 30mm blank at the top and bottom of the sheet. With 13 X 19 paper, the tallest it will print is 16.65 inches. But I want a 12 X 18 print! (And I just did this.)
For paper type, tell the printer you're using "other glossy paper", then manually specify your image size and the border amount you want. Done deal! I printed 12.25 X 18.25 for use with a full 12 X 18 mat. Here's an example of how to print a borderless 11 X 14.
http://www.redrivercatalog.com/infocenter/tips/borderless-11x14-canon-lightroom-windows-2.htmlThis works with Lightroom or Elements or the Print Studio Pro that comes with the printer.
One last tip (for now). Normal printing is done using the "rear paper feed". That's not really true either. There are two paper feeds, both at the back of the printer. There is the "rear paper feed" and the "specialty paper feed", which is actually to the rear of the rear paper feed. So you need to think of the rear feed as the front feed and the specialty feed as the rear feed. :XD: Confused me for a while. 8-)