I purchased a Nikon infra red remote for my D80. Upon receipt, I removed the plastic liner over the battery. It is not activating the camera. I set camera to "bulb" & remote.
Shouldn't I be able to see the infra red light if it's activated? I'm suspecting I have a bad unit or have not set up the camera correctly. I even went so far as to buy a new battery for the remote.
Any suggestions?
As they say, when all else fails, read the directions. I had everything set up correctly, Except I left it on auto focus...works on manual...duh
You can see Infrared light????
MT Shooter wrote:
You can see Infrared light????
Well, that was my next discovery....thinking of laser light...I"m claiming Senior Moment That's my story & I'm sticking to it!
For a second there I thought you were the defacto incarnation of Superman! LOL
MT Shooter wrote:
You can see Infrared light????
If you have an IR filter you can, wanna use mine? lol
saside wrote:
MT Shooter wrote:
You can see Infrared light????
If you have an IR filter you can, wanna use mine? lol
Sure, I'll e-mail you my address.....lol
sah2o wrote:
saside wrote:
MT Shooter wrote:
You can see Infrared light????
If you have an IR filter you can, wanna use mine? lol
Sure, I'll e-mail you my address.....lol
cool I'll e-mail the filter to you
Go page 38 of Nikon guide. You will use one two modes,
Delayed remote or Quick-response remote.
When in one of the modes you must use it within one minute or it return to single frame or continuous shooting mode.
If you want to reply, then
register here. Registration is free and your account is created instantly, so you can post right away.