Ugly Hedgehog - Photography Forum
Home Active Topics Newest Pictures Search Login Register
Main Photography Discussion
URGENT- Err message on D7100
Page <prev 2 of 3 next>
Feb 16, 2016 07:47:09   #
jerryc41 Loc: Catskill Mts of NY
 
This sometimes works. Remove the battery and turn the camera on for about 15 seconds. I've seen the same directions given for solving problems with other electronic gear. Otherwise, get a decent compact camera.

Reply
Feb 16, 2016 08:08:56   #
WilliamCap Loc: Michigan
 
Look at the aperature ring on the lens and make sure its not set to any aperature settings lower than the highest one on the lens aperature ring ON THE LENS itself. Might work............

Reply
Feb 16, 2016 08:21:58   #
ABJanes Loc: Jersey Boy now Virginia
 
I would try putting in a new memory card first. What cards are you using? I had a similar message when my SanDisk Card went bad. Swapped it out and all was fine again. "Go Figure!"

DocBurke wrote:
Hi,

Please help if you can! I am on the first day of a trip to Costa Rica, Panama, and Colombia. Today we were in the rainforest and I was photographing a tanager when suddenly my D7100 didn't work. A blinking "Err" message came on the LCD screen and it sounds like the shutter is very slow. The problem exists when I change lenses or have no lens on at all. I asked for some uncooked white rice at lunch and I'm going to try desiccating the camera in case humidity was the problem. Does anybody have any suggestions that I can try while on my voyage. I am heartbroken!
Hi, br br Please help if you can! I am on the fir... (show quote)

Reply
 
 
Feb 16, 2016 08:25:35   #
JennT Loc: South Central PA
 
MAKE SURE your lenses are properly seated with the aperture ring at its smallest aperture

Reply
Feb 16, 2016 08:30:48   #
ABJanes Loc: Jersey Boy now Virginia
 
I forgot to mention that the problem was intermittent. I would turn the camera off, then back on again, it would work for awhile and then the message returned.

ABJanes wrote:
I would try putting in a new memory card first. What cards are you using? I had a similar message when my SanDisk Card went bad. Swapped it out and all was fine again. "Go Figure!"

Reply
Feb 16, 2016 08:36:50   #
Ed Chu Loc: Las Vegas NV
 
kind of like " Check Engine, " huh ?

Reply
Feb 16, 2016 08:42:41   #
threedeers Loc: Northern Illinois
 
If you have a second card install try putting it into the 1st card slot. I had similar problem with my 7200 and that solved it until I put a new card in #1 slot.

Reply
 
 
Feb 16, 2016 08:43:54   #
boberic Loc: Quiet Corner, Connecticut. Ex long Islander
 
ABJanes wrote:
I forgot to mention that the problem was intermittent. I would turn the camera off, then back on again, it would work for awhile and then the message returned.


Sounds like an electrical connection problem--making and breaking is what we used to call it. In a low humidity air conditioned place carefully clean all electrical contacts. making sure that you leave no residue-do not use a pencil a eraser. Then try a brand new card and fully charged battery. Intermittent problems are a bitch for any one. Hope this helps, If not I guess you will have to send it to Nikon.

Reply
Feb 16, 2016 09:51:52   #
JimBart Loc: Western Michigan
 
I had this message on my 6006 film unit Turns out my autofocus motor was screwed up and I had to shoot manual focus
Also check your lenses if they are set at f22 for autofocus

Reply
Feb 16, 2016 10:58:03   #
LoneRangeFinder Loc: Left field
 
Txauditr wrote:
I had this message on my 6006 film unit Turns out my autofocus motor was screwed up and I had to shoot manual focus
Also check your lenses if they are set at f22 for autofocus


OP did not specify the "fee" message...and setting to f/22 is no longer necessary with a DSLR Nikon with an AF-D lens.

Reply
Feb 16, 2016 11:07:56   #
JimBart Loc: Western Michigan
 
Thanks Lone Range I was not aware of that Just thought I would try based on my experience

Reply
 
 
Feb 16, 2016 11:10:16   #
LoneRangeFinder Loc: Left field
 
Txauditr wrote:
Thanks Lone Range I was not aware of that Just thought I would try based on my experience


I haven't seen the "fee" error message in a while. Maybe when using an old Nikkor lens....

Reply
Feb 16, 2016 11:39:29   #
JFleming Loc: Belchertown, Ma
 
Let this be a lesson for all, NEVER, NEVER go on a trip like this without a backup camera even if you have to rent one!

Several years ago (in my younger days) I had a camera (Pentax) crap out on me in the Florida Everglades and the only thing that saved the day was my wife's camera was a Pentax as well. Between the two of us not all was lost......

John

Reply
Feb 16, 2016 11:52:37   #
donnieb55 Loc: Greensboro, NC
 
I had a similar issue on my D3100. Try removing the battery for a few minutes,l then install the battery, go to the camera menu and hit "reset shooting controls. This is what the people at Costco told me to do and it worked like a charm. I now keep a Minute rice bag in my camera bag to suck up any moisture that might enter the camera. Good luck.

Reply
Feb 16, 2016 12:21:20   #
jerryc41 Loc: Catskill Mts of NY
 
LoneRangeFinder wrote:
OP did not specify the "fee" message...

I think "fee" means the camera is no longer under warranty, and there will be a "fee" to have it repaired. Or, maybe it means something else.

I wonder why they even bother to use those error messages. If the camera isn't working, that's obvious. Displaying "fee," "err," "99," or anything else is pointless. If the message led to a solution, that would make it worthwhile.

Reply
Page <prev 2 of 3 next>
If you want to reply, then register here. Registration is free and your account is created instantly, so you can post right away.
Main Photography Discussion
UglyHedgehog.com - Forum
Copyright 2011-2024 Ugly Hedgehog, Inc.