Canon L series 24-105mm
May 30, 2014 20:33:56 #
For 9 years Canon L series 24-105 has been my go-to lens. Recently, I notice when I change composure to a downward angle, the lens slips. I start at 24 and it slips to 50 or more. Any suggestions?
May 30, 2014 20:55:04 #
Quick response. The internals have become worn. You may wish to consider sending your lens to Canon for assessment and repair or adjustment as needed.
If possible, send it to the shop in Orange County, California. I've had good experience with this facility. Turnaround time: About one week.
You have to register your lens online before Canon will accept it for work.
The whole process goes smooth -- in my experience.
Alternatively, you may wish to try the service of a local repair shop. Ask your camera store for a recommendation.
BTW: I went on road trips with my Canon EF 24-10mm f/4L IS lens for a couple years, and found it a reliable piece of gear with good image quality. Recently, I replaced it with the new Sigma 24-105mm f/4 lens, for its better IQ.
Good luck.
If possible, send it to the shop in Orange County, California. I've had good experience with this facility. Turnaround time: About one week.
You have to register your lens online before Canon will accept it for work.
The whole process goes smooth -- in my experience.
Alternatively, you may wish to try the service of a local repair shop. Ask your camera store for a recommendation.
BTW: I went on road trips with my Canon EF 24-10mm f/4L IS lens for a couple years, and found it a reliable piece of gear with good image quality. Recently, I replaced it with the new Sigma 24-105mm f/4 lens, for its better IQ.
Good luck.
rwdaley wrote:
For 9 years Canon L series 24-105 has been my go-to lens. Recently, I notice when I change composure to a downward angle, the lens slips. I start at 24 and it slips to 50 or more. Any suggestions?
May 30, 2014 21:41:22 #
Lupane
Loc: Gainsville, Ga.
Buy one of those silicon bands to help some form of cancer, wrap it around the lens and it works great! I have a pink one to help breast cancer and it works like a charm without any interference. This way you help research and it keeps your lens from creeping.
May 30, 2014 23:26:13 #
mwsilvers
Loc: Central New Jersey
rwdaley wrote:
For 9 years Canon L series 24-105 has been my go-to lens. Recently, I notice when I change composure to a downward angle, the lens slips. I start at 24 and it slips to 50 or more. Any suggestions?
It is unlikely you would have any better luck getting zoom lens creep repaired by Canon than anyone else. Many Canon zooms develop creep over time. I am not aware of anyone getting the zoom tightened successfully after a trip to Canon.
May 31, 2014 01:17:23 #
rwdaley wrote:
For 9 years Canon L series 24-105 has been my go-to lens. Recently, I notice when I change composure to a downward angle, the lens slips. I start at 24 and it slips to 50 or more. Any suggestions?
RW, that lens was introduced in 05. You must have a very early model.
Most Canon lenses go about 10 years before an update. That lens is due in a year or two.
Either sell it and get a new one, or wait for the mkll, then replace it. Probably not worth fixing.
Lens creep is no big deal, especially when it's a constant aperture. ;-)
SS
May 31, 2014 07:19:47 #
You will spend a lot of money getting Canon to repair it, I had one and it did it from new, went back under warranty and it started doing it 6 months later. Use the latex band or something similar.
May 31, 2014 08:25:10 #
Use a wide but small rubber band in it or you can buy a lens band at B&H or Adoroma....Rich
May 31, 2014 08:38:19 #
Thanks for the tips. I will try a couple bands and see if one helps more than the other.
May 31, 2014 09:03:30 #
SharpShooter wrote:
Lens creep is no big deal, especially when it's a constant aperture. ;-)
SS
SS
:thumbup:
May 31, 2014 09:31:35 #
use it as is....don't let anyone mess with it as they might make it worse and still cost you $$$ You can buy a factory refurb with one year USA warranty for $719 from Adorama right now
May 31, 2014 10:47:04 #
I have that lens but so far have not had that issue. But I asked myself what I'd do if I did start having that happen, and I think I'd just hold the zoom ring at the point I want so as to keep the zoom from changing. It seems pretty easy to hold my 7D with my right hand, finger on button, then with my left hand, hold the lens with thumb and forefinger on the ring to keep it at the spot I want.
May 31, 2014 11:15:29 #
Mine slipped a little for a while, then it locked up so I couldn't move it.
I sent it to Precision Camera who rebuilt it for $100.
I will keep using them.
http://www.precisioncamera.com
I sent it to Precision Camera who rebuilt it for $100.
I will keep using them.
http://www.precisioncamera.com
May 31, 2014 20:16:10 #
Basil, I was attempting a shot looking down from a step ladder. 7d Canon on tri pod. Tough position to hold the lens steady, compose, and change settings. Although I captured the shot it would have been far easier if the lens woul have held a solid position.
May 31, 2014 20:21:15 #
rwdaley wrote:
Basil, I was attempting a shot looking down from a step ladder. 7d Canon on tri pod. Tough position to hold the lens steady, compose, and change settings. Although I captured the shot it would have been far easier if the lens woul have held a solid position.
Yea, I can see where it would be a bit difficult to hold the focus ring in that situation.
If you want to reply, then register here. Registration is free and your account is created instantly, so you can post right away.