Check out Video for DSLR and Point and Shoot Cameras section of our forum.
Glow
Jan 23, 2013 16:28:39 #
Took this shot of an eagle and cropped it to get a little closer, then I noticed the glow around the eagle. Does anyone know what caused it? Took 3 other shots and it was not present on them.
Jan 23, 2013 17:37:54 #
Did you do any post processing? I've seen that result when I did "local tone mapping."
Jan 23, 2013 18:06:48 #
I treated all of the shots the same, this eagle was flying away from me to my left and into the sun.
Check out People Photography section of our forum.
Jan 23, 2013 18:24:40 #
ftpecktim
Loc: MONTANA
If you hit store original people can get a closer look,hard to tell at this size. Could be chromatic aberration emphasized by pp.
Jan 23, 2013 18:49:56 #
Jan 23, 2013 20:33:23 #
Jan 24, 2013 03:57:50 #
Jan 24, 2013 06:22:52 #
Jan 24, 2013 06:45:57 #
dannyp59 wrote:
I treated all of the shots the same, this eagle was flying away from me to my left and into the sun.
Just a guess, but "into the sun" may be the clue - BIF change aspect and lighting very quickly - I would put my money on the light angle reflecting off feathers, like a "hair light" behind a subject in the portrait studio.
Jan 24, 2013 08:11:34 #
andrew.haysom
Loc: Melbourne, Australia
I can see some of the same haloing on the second and third shots too, not as pronounced but definitely there. It looks like a post processing artifact to me too. What processing was done, in-camera and afterwards?
Jan 24, 2013 08:11:50 #
Check out Infrared Photography section of our forum.
Jan 24, 2013 08:28:23 #
Jan 24, 2013 12:47:12 #
This problem of a glowing effect around a subject may occur when you oversaturate or use an over amount of vibrancy. This happened to me, the picture looked good but I wanted to make it better so I laid a little more saturation and there was the glow. Hope this helps!
Jan 24, 2013 13:04:08 #
It is over processed. Just like Buffalo Bills says. I know, been there..done that. Go back and start over, watch your sliders and photo..you should see which one is causing this.
Jan 24, 2013 14:11:44 #
Pixelpixie88 wrote:
It is over processed. Just like Buffalo Bills says. I know, been there..done that. Go back and start over, watch your sliders and photo..you should see which one is causing this.
I agree. If you use CS5 or LR3 some of the sliders can cause this halo effect - especially the Clarity slider. As suggested, post an image that you have not done any post processing to so we can help.
If you want to reply, then register here. Registration is free and your account is created instantly, so you can post right away.
Check out Film Photography section of our forum.