Check out Bridge Camera Show Case section of our forum.
Can someone help identify?
Sep 27, 2016 17:12:06 #
Wenonah wrote:
This was mounted to the wall in an old house.
After looking at this I can see no way on earth it is a hinge or hold-open, it would need pivots on the ends as well as the one in the center.
But I haven't a clue as to what it is or was.
Sep 27, 2016 18:27:55 #
What about a one of two for a table leaf, like on a small writing table?
Sep 27, 2016 22:33:44 #
rfmaude41
Loc: Lancaster, Texas (DFW area)
Wenonah wrote:
That's actually not a bad idea. There are two stop points on the pivot so it would not be able to be closed all the way or opened real far. The knob at the pivot is threaded, to adjust tension probably. Transom windows could ordinarily be closed all the way couldn't they? They had a rod on one side that you push up or pull down to open and close the window.
Depends on how they were mounted...
Check out Infrared Photography section of our forum.
Sep 27, 2016 22:39:05 #
rfmaude41
Loc: Lancaster, Texas (DFW area)
Manglesphoto wrote:
After looking at this I can see no way on earth it is a hinge or hold-open, it would need pivots on the ends as well as the one in the center.
But I haven't a clue as to what it is or was.
But I haven't a clue as to what it is or was.
Note that the "upper end" has two holes for mounting, and, the lower end has two also, which are at "right angles" to the upper ones. It would NOT need pivots to function properly, depending on how it is mounted...
Sep 28, 2016 04:23:34 #
rfmaude41 wrote:
Note that the "upper end" has two holes for mounting, and, the lower end has two also, which are at "right angles" to the upper ones. It would NOT need pivots to function properly, depending on how it is mounted...
If you say so, but I disagree.
If you want to reply, then register here. Registration is free and your account is created instantly, so you can post right away.