I want to test this to find out if it is oprating properly. I used to know how to test the flash but haven't operated it in a while and don't remember. What batteries etc how to test it. I hafe the sensor and the strobe . no other cables.
Thank You
last time I tested a flash I opened the back of the camera, without film in the camera I aimed the flash toward the lens, and if it fired when the shutter was open I knew it worked. If I did more than that I don't remember, its been a long time.
Gann wrote:
I want to test this to find out if it is oprating properly. I used to know how to test the flash but haven't operated it in a while and don't remember. What batteries etc how to test it. I hafe the sensor and the strobe . no other cables.
Thank You
It takes 4 C NiCad batteries. You will need a PC cord and, unless you hand-hold the flash, the camera bracket. The trigger voltage is 4-193, be careful!
Here's the PDF manual:
http://dpanswers.com/manuals/sunpak_611_man.pdfEdit: The trigger voltage with C batteries should be safe. I think the higher voltage is with the AC adapter or 510 V Powerpack.
BHC
Loc: Strawberry Valley, JF, USA
The pin readout on the control head is camera specific. What camera does it fit?
I will read it later today and let you know. I tested it before and thought I did it without the camera. I would need to test it on a Nikon F100.
I will read the manuel later this evening.
Thanks
BHC
Loc: Strawberry Valley, JF, USA
The manuel download is encrypted- the Sunpak download is encrypted. where can I get one that isn't.
If you want to reply, then
register here. Registration is free and your account is created instantly, so you can post right away.